MS Schippers MS Fogger XXL, Manual

Page: 9 / 12

Startup

Place the plug in an earthed socket. The red lamp under the tank will light up,
this is a low pressure alarm.
 Make sure the place/room for disinfection is hermetically sealed.
 Switch on the fan using the off/on
fan switch (3-1). With an EC motor fan it takes
a few seconds before the fan starts up!

Switch on the high-pressure pump. Press the
high-pressure pump button (3-2)
and keep it pressed for a few seconds until the red lamp turns off. To speeds up
startup when starting up with empty system (no water in the high-pressure
pipework), open the
flush valve (3-3) under the fan, keep the button pressed
until there is a steady flow of liquid. Then close the valve, the pressure in the
system increases and the red lamp turns off, you can now release the push
button.
 Check the correct operation of the nozzles, in case of irregularities press the
high-pressure pump button (3-2) again to switch it off manually. In case of
irregularities check the maintenance list.

When operating correctly, leave the room and close the door.

When the liquid has been nebulized, the pressure drops and the high-pressure
pump stops automatically. The red lamp lights up again.
 If the machine is not used in the next room/place within a reasonable time
(24h), start the ‘rinsing’ procedure.

If the machine is to be used in a next room/place, stop the fan, remove the
power plug from the socket, and move the machine to the next room/place.
 Repeat all steps from the 'preparation' procedure.
Rinsing

Open the
rinse valve (2-3) and the filling covers/lid (1-3) until the rinse tank (2-2)
emptied into the main tank.
 Close the
filling covers/lid (1-3).
 Follow the ‘Startup’ procedure.

When rinsing has finished, stop the fan, remove the plugs from the socket and
move the machine to storage area.