User manual
500GD
20 / 52
MRU GmbH, D-74172 Neckarsulm
Use interchangeable sensor with probe tube
►
Insert the desired interchangeable sensor into the
sensor
connector.
►
Make sure that the interchangeable sensor clicks into place audibly.
►
Switch on the analyser.
See also Chapter 4.3 Switching on the analyser, Page 14.
The analyser automatically identifies the inserted
interchangeable sensor.
An information window appears in the display for approx. 5
Seconds.
A message
“Attach the probe tube” appears.
Depending on the interchangeable sensor, a warm-up phase
appears.
An animation for attaching the probe tube appears.
►
Screw the probe tube onto the base unit.
A fan symbol appears in the display.
Set alarm mode
The analyser can indicate an exceeding of the set alarm thresholds by
an acoustic signal as well as by vibration
You can set how the analyser should react when the set alarm thresh-
old is exceeded.
NOTE
Note that a interchangeable sensor must be plugged in
to set the alarm mode.
Note that the setting of the alarm mode is carried out in
the measurement window.