SFH-50 Quick Start Guide
29
4.
CAM ACC
Camera Accessory input/output connector. It has pins for
three stepper motors, two serial lens controls, two trigger in
controls, and two trigger out controls. For pin-out information see
Camera Accessory connector
on page 31.
5.
DATA
DataLink In (Up Link) connector for controlling the head
using a DataLink connection, as an alternative to an Ethernet or
Serial RS232 connection. You connect this to a device that is further
up the DataLink daisy-chain, such as one of the following:
The
DATA OUT
(or
DOWN LINK
) connector on a controller
such as the MSA-20 Handwheels or Large Format Panel (LFP).
The
RIG/HEAD
connector on an RT-12 interface box which is
in turn connected to a PC running Flair Motion Control
Software.
Note that because there is no DataLink Out connector on the
Ulti-box, the Ulti-box must be connected at the end of the DataLink
daisy-chain rather than the middle. For pin-out information see
Data In connector
on page 32.
6.
ETHERNET
RJ45 connector for controlling the head using an
Ethernet network connection, as an alternative to a DataLink or
Serial RS232 connection.
7, 8.
ZOOM
,
FOCUS
connectors for external servo Lens Control Motors
(LCMs). For pin-out information see
Servo motor connector
on page
30.
9.
TILT
connector for the Tilt servo motor on the head. For pin-out
information see
Servo motor connector
on page 30.
10, 11.
AUX-1
,
AUX-2
connectors for control of auxiliary servo motors.
For pin-out information see
Servo motor connector
on page 30.
