Broadcast Jib Arm Quick Start Guide
8
Jib Arm
Setting Jib Arm Weight:
Lift cable
Load
platform
Trim
weights
1.
Power up and jog the arm to the horizontal position using the
HEIGHT
rocker switch. If the cable is slack and the arm does not fall,
Caution:
DO NOT lift and try to lower the Jib arm by hand unless
guided by the procedure below. The cable should remain under
tension all the time.
Caution:
DO
NOT place any object greater than 4.2kg on the load
platform.
Caution:
DO NOT remove all the balance weights with a payload on
the load platform.
Caution:
Ensure that you follow the “Setting Jib Arm Mass”
procedure below before operating under fully automated control.
You will need to set the trim weights only once so long as the
payload is not changed.
Summary of Contents for MRMC-2165-00
