Mimic Handwheels Quick Start Guide
9
Mimic Handwheels Quick Start Guide
Appendix 1
Troubleshooting
Typical symptoms, causes, and actions
Symptoms or message
Cause and/or action
Controls move in the
wrong direction
Change the working direction of the controls
to your preference.
Limits are being
ignored or causing the
head to oscillate when
reached.
The axes have not been zeroed. You must do
this at the beginning of each session just after
you load the head.
When you set soft limits, you must set the
MAX limit to the higher (or more positive) axis
value, and set the MIN limit to the lower (or
more negative) value.
Check the scaling of the axis on the Mimic
Handwheels. If the axis is moving too fast, then
lower the scaling and vice versa if it is going
too slow.
Can’t set limits, or the
head oscillates when
you set a limit.
The head moves too
slowly or too quickly.
Summary of Contents for MIMIC HRNDWHEELS
