Mimic Handwheels Quick Start Guide
7
5.
Check that Flair is receiving data from the encoders in the Mimic-
Handwheels by using Flair menu option
Setups
>
Test Mimic
Inputs
and making sure that the relevant Root mimic axes numbers
change when you move the handwheels:
–
Typically the left wheel is assigned to Pan axis on the
head and appears as Ric Axis 1.
–
Typically, the middle wheel is assigned to Tilt axis on the
head and appears as Ric Axis 2.
–
If a Zoom controller is plugged into the
ZOOM
port and
the
ROLL
/
ZOOM
switch is in the ZOOM position, then
this will appear as Ric Axis 3. If the
ROLL
/
ZOOM
switch
is on the
ROLL
position, then the right wheel can be
assigned to Roll axis and appears as Ric Axis 3.
–
If a FIZ pot or Zoom controller is plugged into the
FOCUS
port at the rear, then this will appears as Ric Axis
4.
6.
In the Flair window, click
Show Mimic
. The additional Root Mimic
options appear below each rig axis.
7.
In the Controller drop-down, specify which Root Mimic axis you
want to control this axis, for example to assign Pan to Wheel 1,
select the Controller as
Rt Mimic 1
, or
RIC Mimic 1
:
Summary of Contents for MIMIC HRNDWHEELS
