How To Use Advanced Functions
Page 10
mrcool.com
SET function
or
SET
SET
OK
Press the
SET
button to enter the function setting, then press the
SET
button or the
TEMP
or
buttons to select the desired function. The selected symbol will flash on the display, press the
OK
button to confirm and this will activate the selected function.
To cancel the selected function, just perform the same procedures as above.
Follow Me function ( ):
The
Follow Me
function enables the remote
control to measure the temperature at the
location it currently is and send this signal to
the air conditioning unit in a 3 minute interval.
When using
AUTO, COOL, or, HEAT
modes,
measuring the ambient temperature from the
remote control (instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature where you currently
are and ensure maximum comfort.
NOTE:
The air handler may be equipped with AP
mode, which allows the unit to use the
wireless network configuration. However,
the air handler does not respond to the AP
mode signal from the remote controller.
The wired thermostat must be used to
activate this feature if so equipped.
Press the
SET
button to scroll through operation functions as follows:
Follow Me* ( )
[ ]: If your remote controller has a Follow Me button, you cannot use the SET button to select
the Follow Me feature.
*