MRC RL-1250, Operation Manual, Page: 3 / 6

III
、
ACCESSORIES
1. Stirring Shaft (SUS#304):
ψ
8 × L500mm----------1 PC
2. Propeller (SUS#304): No.8
，ψ
50mm----------1 PC
3. Stand Base: W400×D315×H54mm
，
8Kg----------1 PC
4. Holder----------1 PC
5. Pole----------1 PC
IV
、
OPERATION INSTRUCTION
1. Be sure to plug in correct power supply, then open the power switch.
2. Speed (rmp) setting:
A. Adjust the speed knob to increase speed gradually and to be the proper speed.
B. Press
【
START
】，
the machine can start stirring and get to the setting speed.
3. Kg-Cm and RPM options
：
A. Press
【
FN
】
for getting Kg-Cm or RPM option.
4. Time setting:
A. Press [
Ÿ
] (flash)
→
00:00 (The first 0 is flashing.)
B. Press [
X
] or [
S
] to set time.
C. Press [
Ÿ
] again to save the setting.
D. Press [START] to start the time to count down.
E. Press at any time during the stirring, the set time will be appeared.
F. The machine will stop automatically as soon as time is up.
5. When the temperature of the driver reaches 70°C, the motor will stop running for
preventing from burning out and the re-performance will be allowed to start only when
the temperature is less than 55°C (need around 30 mins). If the situation happens
again after re-starting the machine, the machine should be reduced the loading on the
stirrer.
6. Fuse will automatically burn out itself and cut off the source under over-low voltage,
over-load current and over-heat temp.
2