3, Hagavish st. Israel 58817 Tel: 972 3 5595252, Fax: 972 3 5594529
com
.
mrclab
@
mrc
Location Conditions
DANGER
Never install or use this equipment in explosive atmospheres.
Never install or use this equipment with or near to hazardous
or flammable substances.
Never expose this equipment to any heat sources including
direct sunlight.
Never install this equipment closer than 20 cm (8 inches) to a
wall of combustible material.
Never install this equipment near any device that generates
high frequency noises.
Set up this equipment on a flat, stable, clean, non-slip, dry, and
fireproof surface inside a lab with proper safety measures.
Observe the minimum distances (in general, 30 cm or 12
inches) from other devices. In addition, any device which can
be affected by the motor vibrations should not be placed near
this equipment.
Connecting to Power Supply
When connecting power, use only the power cord that came with
your instrument. The power connection procedures are as follows:
(1)
Before connecting the power cord, make sure that the main
power switch is turned off.
(2)
Plug the other end into a properly grounded and dedicated
power outlet nearby.
