MRA X-Creen, Mounting Instruction

Page: 3 / 5

When tightening, the XCC bracket is compressed and the rubber washers are pressed against
the windscreen. First the front rubber washers and then the back ones with further tightening.
Tighten the screws so that the back rubber washers are as compressed as the front rubber
washers (P3).
7. Press the caps (20) on the nuts and tighten the screws M4x20 (11) of the mounting feet (9).
E - Removing the X-screen spoiler with XCC clamps
1. Remove the caps (20) and loosen the nuts on the M6x30 clamp bolts.
2. Now you can carefully pull the X-screen spoiler with the XCC clamps (14) carefully off upwards
(14).
Should the clamp tension still be too strong, you may have to loosen the bolts a little more.
3. You can also use the bolts (21), conical sleeves/bushings (22) and nuts (23) supplied to open the
clamps wider (e.g. if the windshield has a bulge), inserting them crosswise into the XCC clamps
and screwing them shut as shown in P4.
E - Changing from Option "S" to Option "D":
1. Remove (2) by moving it a little in a transverse/sideways direction and then pulling it out.
2. Remove (4) and (8).
3. Remove the screws M4x20 (11).
4. Assemble the parts as described in section B "Assembly Process for Option D".
F - Changing from Option "D" to Option "S":
1. Remove (2) by moving it a little in a transverse/sideways direction and then pulling it out.
2. Remove (4) and (5).
3. Remove the screws M4x20 (11).
4. Assemble the parts as described in section A "Assembly Process for Option S".
Only ever clean your X-creen with water, neutral soap and a sponge.
Never wipe your X-creen with a dry cloth or use solvents as these may
scratch or damage its surface.
Check for a secure fit before each trip.
Never adjust the spoiler while you are riding!
We hope you find increased comfort and a more relaxed riding experience
with your new MRA screen installed.