3
GB
MOUNTING INSTRUCTIONS
DUCATI Multistrada V4 2021-
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorised workshop.
Number
Article
Article No..
Required tools
1
MRA windscreen
---
Allen key 3mm
Torx TX 25
2
Fillister head screws M5 x 30mm
10566
2
Fillister head screws M5 x 20mm
10673
4
Plastic washer 12 X 5 x 0.5mm
10635
2
16 X 4.5 X 4mm neoprene washer
10634
2
15mm spacer
10636
2
O-ring 4.5 X 1.5
10992
Mounting the windscreen onto the motorcycle:
1. Place the motorcycle on a flat surface.
2. Dismantle the original windscreen.
3. Remove the black rubber grommets from the original windscreen and insert these at the
fastening points on the motorcycle (P1).
4. Insert the M5 X 20mm fillister head screws [10673] through the
bottom
drill holes of the
MRA-windscreen with the plastic washers [10635] and place the 4mm neoprene washers
[10634] against them from behind (P2).
5. Insert the M5 X 30mm fillister head screws [10566] through the
top
drill holes of the MRA
windscreen with the plastic washers [10635] and place the 15mm spacers [10636] against
them from behind, and secure these with the delivered O-rings [10992] (P3).
6. Now, mount the MRA windscreen onto the motorcycle (tip: First, turn all screws a few times
before carefully tightening them fully.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: [email protected]
Summary of Contents for Multistrada V4 2021
Page 7: ...7 P 1 P 2...
Page 8: ...8 P 3...
