MRA MRA0163, Mounting Instructions, Page: 3 / 7

3
GB
MOUNTING INSTRUCTIONS
BMW G310GS 2017-
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorized workshop.
Number Article Article No.. Required tools
1 MRA windscreen --- Allen key 3mm
Torx T30
2 Distance sleeves M6 20mm 11181
2 Distance sleeves 15mm 10636
2 Lens head screws, M5x35mm 10632
2 Lens head screws, M5x30mm 10566
4 Plastic discs 12x5x0.5mm 10635
4 O-rings, 4.5x1.5mm 10992
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the original windscreen.
3. Insert the M5x35mm lens head screws [10632] with the plastic washers [10635] into
the upper holes on the MRA windscreen. Then, slide the 20mm distance sleeves
[11181] onto the lens head screws [10632] from the back and secure these with the
provided o-rings [10992].
4. Insert the M5x30mm lens head screws [10556] with the plastic washers [10635] into
the lower holes on the MRA windscreen. Then, slide the 15mm distance sleeves
[10636] onto the lens head screws [10566] from the back and secure these with the
provided o-rings [10992] as well.
5. Attach the MRA windscreen to the motorbike and centre the windscreen. Fully tighten
the lens head screws.
6. Attach the provided edge protector shown in image 2 to the windscreen.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de