MRA 4025066150526, Mounting Instructions

Page: 3 / 8

3
GB
MOUNTING INSTRUCTIONS
Kawasaki Z800
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorised workshop.
Number Article Article No.. Required tools
1 MRA screen --- Allen key 3, 4, 5mm
Socket wrench 10mm
Wrench 10mm
1 Holding plates 10867
2 Set of Bolts M6 x 12 10866
2 Nuts M6 10871
2 Domed screws M5 x 16 10554
2 Domed screws M5 x 25 10641
2 Spacer 10633
4 Plastic washers 10635
1 Edge protection strip, sleeves ---
Fitting the screen to the motorcycle:
1. Unscrew the screws and remove the original screen (P1).
2. Unscrew the Allen screws and remove the bracket (P2).
3. Mount the bracket on to the supplied retaining plate (P3) and attach this to the
fairing.
4. Bring the MRA screen into position. Secure the screen using the M5x16 screws above
and use the M5x25 screws together with the 10mm distance sleeves below and in
each case with the plastic washers.
5. Fit the protective edge strip on the rear exposed part of the screen, starting where the
fairing overlaps and continuing to the opposite side. Any remaining strip should be cut
away.
6. It is also possible to push the clamping sleeves over the ends of the protective edge
strip and lightly compress these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de