IV. INSTALLATION INSTRUCTIONS FOR CEILING
FAN REMOTE CONTROL
A. IMPORTANT POINTS:
B. OPERATION INSTRUCTIONS:
C. FUNCTIONS OF TRANSMITTER:
1.
2.
3.
4.
5.
6.
7.
8.
Please read this manual and keep it for future use.
Turn off the electrical mains at the circuit breaker/fuse box.
Please note that all wiring connections should be done by a qualified electrician.
This unit is to be used in an AC220V / 50Hz supply zone only.
Do not install in damp locations or immerse in water. (For indoor use only.)
To avoid damaging the transmitter prevents dropping or banging the transmitter.
Do not attempt to shorten the receiver’s antenna wire.
If the transmitter is not used for some time, please remove batteries to avoid leakage
that will damage the transmitter.
1.
2.
After installing the receiver, make sure the transmitter has its batteries installed.
If the transmitter is not functioning properly or not function or if the fan is not moving
please do the followings:
a) Turn off the electrical mains at the circuit breaker/fuse box.
b) Follow steps on page 9-10 to reinstall the receiver.
HI
MED
LOW
OFF
LIGHT ON
LIGHT OFF
Set fan to high speed.
Set fan to medium speed.
Set fan to low speed.
Turn off the ceiling fan.
Turn on the light.
Turn off the light.
:
:
:
:
:
:
NOTE:
THE TRANSMITTER IS DESIGNED FOR USE WITH EITHER WALL BRACKET
FOR TRANSMITTER (d.) OR THE TRANSMITTER COVER (b.)
LIGHT ON
LIGHT OFF
LOW
OFF
HI
MED
Put the transmitter into transmitter cover.
Wall bracket for transmitter
(If desired, install onto the wall with screws.)
LIGHT ON
LIGHT OFF
LOW
OFF
HI
MED
