MQ Multiquip WHITEMAN CA4HC, Operation Manual

Page: 23 / 46

PAGE 22 — CA4HC WALK-BEHIND TROWEL • OPERATION MANUAL — REV. #1 (06/24/20)
Throttle Cable Installation
1. Set the throttle lever to the idle position (lever away
from the operator). See Figure 7.
Figure 7. Throttle Lever (Standard Handle)
2. Uncoil the throttle cable and housing.
3. Make sure the throttle cable is fed through the tube on
the underside of the handle and secured to the upper
handle and main tube with zip ties.
NOTICE
The throttle cable length is preset and installed in the
throttle lever at the factory.
THROTTLE
CABLE
THROTTLE
LEVER
RUN
POSITION
IDLE
POSITION
SETUP
4. Loosen the cable housing clamp screw and the swivel
stop screw (Figure 8).
Figure 8. Throttle Cable Installation
5. Place the primary throttle return spring between
the cable housing clamp and the swivel stop screw
(Figure 8).
6. Feed the cable assembly through the cable housing
clamp, return spring, and swivel stop hole, until the
cable housing extends under the housing clamp to its
far edge (Figure 8).
7. Adjust the throttle cable at the throttle lever on the
handlebar (Figure 9).
Figure 9. Throttle Cable Adjustment
CABLE
END
SWIVEL STOP
SWIVEL
STOP HOLE
SWIVEL
STOP SCREW
RETURN
SPRING
CABLE
HOUSING END
CABLE
HOUSING
CLAMP
CLAMP
SCREW
THROTTLE CABLE
ADJUSTER
NUT
THROTTLE
LEVER
IDLE
DETENT
THROTTLE
CABLE
THUMBWHEEL
ADJUSTER
To
order
go
to
Discount-Equipment.com