EV2632-R-01A – 3A CHARGER, 3A BOOST DISCHARGE, ALL-IN-ONE
EV2632-R-01A Rev. 1.01
www.MonolithicPower.com
6
1/14/2016
MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2016 MPS. All Rights Reserved.
EQUIPMENT REQUIREMENT
Evaluation requires the following equipments:
1. DC power source. The output voltage should exceed 6.0V, and output current greater than 3A.
2. Battery simulator or a single-cell battery pack. The battery simulator’s output rating should
exceed 4.5V/7.0A. When using a real battery pack, please observe all precautions on the
battery manufacturer’s data sheet first and ensure the charger’s setting doesn’t exceed the
battery’s absolute maximum specifications.
3. Oscilloscope. A single voltage probe and a single current probe.
4. Multi-meter.
Charge Function
1 Connect the jumper “VCC”.
2 The jumpers “DCP”, “SDP1” and “SDP2” are used for the input DP1/DM1 detection setting.
Connect “DCP” and leave “SDP1” and ”SDP2” float as default, the DP1/DM1 detection will be
set as DCP, the I
INLIMIT
is set through R
ILIM
.
Otherwise, only connect “SDP1” and “SDP2”, or leave the 3 jumpers float will set the I
INLIMIT
=
500mA.
3 Attach the positive and negative ends of the battery to the “BATT” and “GND” terminals,
respectively. If it’s a battery simulator, please preset the voltage to 3.8V (typical value) first.
4 Preset the DC power source to 5.0V. Then attach the DC output port and ground to the “VIN”
and “GND” terminals, respectively.
5 Turn on the DC power source. The charger will start. Use the oscilloscope to verify that the 3A
charge current is being delivered to the battery.
U1
MAIN CIRCUIT
EV2632-R-01A
GND
VIN
BATT
GND
1-Cell
Battery Pack
or Simulator
JP1
LED3
VNTC
AGND VCC
NTC
VB
L
H
JP2
VCC
GND
SYS
LED2
LED1
LED4
DCP
SDP1
SDP2
SW1
DC
Power
Supply
Figure 4: Setup for Charge Mode
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from