Circular Sawblades
Suggested:
Single Handle File
Fine:
For regular maintenance
Coarse:
For dull blades
TECHNICAL DATA
Code
Grade Grit Micron
Router Bit
Fine
600
25
Sharpener
Coarse 300 50
Credit Card
Fine
600
25
Stone
Coarse 300 50
Single
Fine
600
25
Handle File
Coarse
300
50
Twin Handle
Coarse
300
50
File X/C
Ex. Coarse 100
140
Twin Handle
Fine
600
25
File C/F
Coarse
300
50
8” Bench Stone Super Fine 1000 15
Coarse
300 50
MOUNTING THE 8” BENCH STONE ON
THE DIAMOND STONE HOLDER
The 8” bench Stone comes with two
diamond stone holders.
Attach one diamond
holder to the underside
at each end of the
stone using the
magnetic lock to secure
in position.
To prevent skidding ensure
worksurface is dry, flat and
clean of debris.
ROUTER BIT SHARPENER
CREDIT CARD STONE
SINGLE HANDLE FILE
TWIN HANDLE FILES
BENCH STONE
followed to ensure that the stone will give
lasting performance under normal
conditions.
Follow the hints and tips explained here
to help maximise the life of your Diamond
Cross Stone:
All tooling should be cleaned before
sharpening. Resin build-up should be
removed with Resin Cleaner and a wire
brush.
Use with Diamond Abrasive Lapping
Fluid (water can be used if necessary),
this will prevent the diamonds
becoming clogged with swarf.
Diamond Cross Stones require a
'break-in' period. Initially the diamond
will feel coarse and will smooth
overtime.
Do not apply too much pressure.
The diamond is extremely abrasive so
what would normally take 5-10 minutes
on an oilstone may take approximately
20 seconds on the Diamond stone.
Dry the Diamond Cross stone
thoroughly after use. Any wet steel
filings left on the stone will cause
surface rust to form.
DIAMOND CROSS
Thank you for purchasing this product.
The following symbols are used
throughout these instructions.
Denotes risk of personal injury, loss
of life or damage to the tool in case
of non-observance of these instructions.
Refer to Power Tool instructions.
INTENDED USE
This product is intended to be used to
sharpen steel, tungsten carbide & high
speed steel tools. For both professional
and domestic use.
SAFETY
Please read and understand these
instructions before use.
Users must be competent in using
Woodworking equipment before using our
products.
All cutting edges are very sharp and care
must be taken to prevent injury.
GUIDELINES
Diamond Cross stones allow fast, clean
stock removal,with less effort and time
required and can be used on a variety of
cutting edges.
When using Diamond Cross stones,
certain general guidelines should be
OPERATION
Router Bits/Cutters
Suggested:
Router Bit Sharpener
Fine:
For Tungsten Carbide.
Coarse:
For High Speed Steel.
Always sharpen the flat face,
never the profile/relief.
Slide the cutter with slight
pressure along the whetstone.
Repeat same number of strokes
on each cutting edge.
Chisel/Plane Irons
Suggested:
8” Bench Stone
Fine:
For edge honing
Coarse:
Areas of minor damage
Finish with one light stroke on
the back of the chisel.
It is recommended to use a figure of eight
motion when sharpening chisels.
Keep the bevel of the chisel/plane
iron flat on the stone.
Keep the diamond
surface flat to
the face of saw
tooth.
Use a few light,
smooth, back
and forth strokes
on each tooth.
Repeat the same
number of strokes on
each tooth.
Mark the first tooth sharpened
with chalk or masking tape to
avoid honing a second time.
UNIVERSAL
INSTRUCTION MANUAL
re-cycle
read
version
2
