14
GB
JUICE EXTRACTION PROCEDURE
1.
Wash fruits and vegetables you want to use accurately.
2. In order to achieve the best productivity during extraction of juice from such fruit as:
grapes or quinces wash the cutting plate after 0,5 kg of fruit.
3. Put the juice container under the juice outflow (8).
4. Insert vegetables and fruit into the hole (2).
Attention
:
Before products are inserted, switch the juice extractor on turning the switch
into 1 or 2 position.
5
. Push the fruit through the hole (2) using the pusher (3).
6. Every few minutes check whether the waste container (5) is full – if necessary, switch
the unit off and empty the container.
7. In case when the unit vibrates and generates less amount of juice than it is expected,
disassemble the unit and wash the cutting plate - hard vegetables and fruit can slow
down the engine work. Consequently, do not overload the unit if you work with such
products.
8. The unit’s working time cannot exceed 2 minutes. After 2 minutes have passed, switch
the unit, wait 3 minutes and switch it on again.
Attention:
Never open the cover when the juice extractor works!
The handle (clips) to close the cover must be in cover-blocking position.
Attention:
It is recommended to extract soft fruits/vegetables using lower speed of the
engine and higher speed for harder and less juicy products.
Speed of the unit’s work enables generation of about 0,45 L of juice per one minute of
work.
GENERAL REMARKS
1
. If possible, use fresh and ripe fruit and vegetables.
2. Soft and too ripe fruit will result in non-pure juice.
3. Apple juice may become brown quickly – to slow down this process add a few drops of
lemon juice.
4. Before you insert fruit or vegetables into the juice extractor, we recommend removing
all leaves and stems.
5. Do not extract juice from rhubarb and currants.
6. If a juice is too dense, add some water.
DISASSEMBLY OF THE JUICE EXTRACTOR
1
. Switch the unit off (7) and take a plug from a socket.
2. Wait until the cutting plate (4) stops.
3. When juice stops flowing, remove the juice container (12) and pour the juice into glasses
or other container.
4. Remove the pusher (3) from the hole (2).
5. Remove the cover (9), do not forget to open the safety handle (clip) (6).
6. Empty the waste container (5).
7. Disassemble the separator (8) together with the cutting plate (4).
MSO-02M_instrukcja.indd 14
2012-02-15 12:06:36
