2
Issue 01.2021
Installation
Please clean the frames carefully before mounting the
sealant.
Follow the instructions of the sealant manufacturer.
Separate the inner and outer frames and fit the outer frame
to the outside of the roof aperture onto a bed of sealant.
The operating handles facing the front and rear of the
vehicle!
Correctly align the upper frame and the installation frame and
secure evenly with the screws.
Max. Torque 0.5 Nm.
Make sure that the recesses of the mounting frame are on the
sides of the handles.
Correctly position the plissé frame to the inner mounting frame
and clip it into place. Special centring devices will help to find
the right position.
Operation
To open the rooflight, press both locking buttons and push the handles upwards.
The rooflight can be opened fully by the handles or in four different directions, so that the
dome can be angled against driving weather conditions.
To close the rooflight, press the locking buttons again and pull the handles down. The roof
hood is locked.
Keep the pleated blinds open while driving to avoid driving noise and damage
from the airstream.
To avoid heat accumulation do not close blind completely during the day. Open
both pleats when not using the vehicle.
Cleaning
Dome
For easier cleaning of the dome it can be removed from the frame
by releasing the four screws holding the handle arms.
Never remove the screws holding the dome and the
handles together. These are secured by a torque
screwdriver and should only be handled by an approved
dealer.
Use only clear water and a soft sponge.
Solvents may attack the plastic and make it brittle.
Clean the gaps by immersing the hood in a container filled with
water. Let the dirt soak a little.
Use the two handles to pull the hood through the water so that the
dirt can be washed out.
Make sure that only the original screws are used when
replacing the dome and they enter the thread in the plastic
correctly. Do not over-tighten.
Pleated frame
Release the 4 fixing clips with a screw driver to remove the frame.
Please release carefully to not damage the clips.
Clean the pleated blinds with a soft brush, dry cloth or feather
duster.
We strongly advise against wet cleaning, as this can
damage the insect screen and blackout pleated blind.
Warranty
The legal warranty applies.
mpk-kierspe.de/Downloads
