84
4
MEDIA SETUP Menu
NOTE:
When Clip Page = Disable, the correct Label Length value must be
entered. If the value is too long, the printer will ignore the actual gap
or mark it needs to detect. When using Gap sensing, the Label
Length value is equal to the physical length of a die cut or removable
label. When using Mark sensing, the Label Length value is the
physical distance from the leading edge of one black mark to the
leading edge of the next black mark.
Fault Reprint
This option determines how the printer handles data that was printing when
an error occurred.
•
Disable
(factory default). The printer will not reprint the label that was
printing when the error condition occurred.
•
Enable
. The printer reprints the label that was printing when the error
condition occurred.
NOTE:
When Fault Reprint is set to Enable and a RIBBON OUT condition
occurs, some labels may not reprint. This depends on the label
length, print speed selected, and the additional time it takes to detect
this condition. Be sure to verify that all labels were reprinted after a
RIBBON OUT condition by using the Ribbon Low indicator as
described on page 84.
Ribbon Low
When enabled, and the ribbon remaining on the supply spindle is less than
1/8 full, the Attention indicator will flash, and "Ribbon Low" displays on the last
line of the LCD. A Ribbon Low warning will not prevent printing.
The options are Disable (factory default) and Enable.
Ribbon Low displays if Admin User is set to Enable in the PRINTER SETUP
menu.
Units
This item selects either millimeters or inches as the unit of measure.
The options are In Inches (factory default) and In Millimeters.