SHOP MANUAL MT26-31 - 06.2005
Engine
Tier-3 710655-
Ch 1
page
94
Apply the sealing agent on the timing gear
housing side against the transmission plate.
Apply the sealing agent around the screw
holes marked with arrows.
Fitting flywheel housing
1.
Remove all old sealing compound on the sealing surfaces of the
timing gear casing and timing gear plate.
Clean off any oil and grease using an alcohol based cleaning
agent.
Note:
The sealing surfaces must be absolutely clean and free from
grease. Do not touch the surfaces after degreasing.
.
Apply the sealing agent (51565) on the timing gear housing with
the air powered sprayer (51559), cartridge adapter (51565) and
nozzle (51558).
The width of the bead should be between 0.8 and 1. mm.
Follow the pattern as illustrated.
Important!
Ensure that you apply sealing agent inside the screwholes,
but without allowing sealing agent into the crankcase.
The sealing agent may block channels and nozzles.
This is particularly important to bear in mind around oil ways,
where the flow of oil to the air compressor or injection
pump can be blocked.
Important!
Assembly must be completed within
25 minutes of starting to apply the sealing
agent.
Note:
The bolts are of various sizes and
lengths. Ensure that they are fitted
in the correct places. See also the
illustrations on the next page.
3.
Torque tighten the M1 bolts to 90 Nm and
the M10 bolts to 50 Nm.
4.
Fit the starter motor
Summary of Contents for MT 26
