- 5 -
When installing TC-6110 computers at a field site, follow these steps:
Step 1:
Connect the ends of the extended power switch cable to the male
portion of the 2-pin Euroblock (provided); you may also choose to not use
the cable extender, and connect the switch to the terminal directly.
Step 2:
Plug the male Euroblock into the matching female terminal on the
front panel.
Step 3:
Make sure the power switch is turned off (the
Open
position as
indicated in the diagram
below).
Step 4:
Connect the earth/ground cable to the
Phillips-head ground connector on the lower right corner
of the front panel.
Step 5:
Connect the M12 connector to the power source using the pin
assignment at right.
Step 6:
Connect this M12 connector to power input 1 on the front panel of
the computer.
Step 7:
Use the same method to provide power to power input 2.
Step 8:
Turn on the computer. If the power supply is connected properly,
the
Power
and
System Power
LEDs will be on, and the yellow
Ready
LED will also be on. If you need to disconnect the power, reverse these
steps.
Please note that the branch circuit over current protection must be rated
maximum 10 A.
