- 5 -
Turbo Ring DIP Switch Settings
The default setting for each DIP switch is OFF. The
following table explains the effect of setting the DIP switch
to the ON position.
Turbo Ring Settings
DIP
DIP 1
DIP 2
DIP 3
DIP 4
–
Ring Master Ring Coupling
port
DIP 1, 2, 3
ON
–
Enable
Enable
Activates
Default OFF
–
Disable
Disable
Disabled
Turbo Ring V2 Settings
DIP
DIP 1
DIP 2
DIP 3
DIP 4
Ring Coupling Ring Master
Ring Coupling
port
DIP 1, 2, 3
ON
Backup port
Enable
Enable
Enable
Activates
Default OFF
Primary port
Enable
Disable
Disable
Disabled.
Software Installation Information
For the NPort’s configuration, the default IP address of the NPort is:
LAN: Static IP = 192.168.127.254; netmask = 255.255.255.0
You may log in with the account name
admin
and password
moxa
to
change any settings to meet your network topology (e.g., IP address)
or serial device (e.g., serial parameters). You may also refer to Moxa
support website
https://www.moxa.com/support
for user’s manual,
driver, SNMP MIB, and NPort Search Utility.
NOTE
For NPort with DB Male serial ports, you may refer to the DB9
Male Ports pin assignment section to loop back pin 2 and pin 3
for the RS-232 interface to carry out a self test on the device.
Pin Assignments and Cable Wiring
DB9 Male Port Pinouts
Pin
RS-232
RS-422/
RS-485-4w
RS-485-2w
1
DCD
TxD-(A)
–
2
RxD
TxD+(B)
–
3
TxD
RxD+(B)
Data+(B)
4
DTR
RxD-(A)
Data-(A)
5
GND
GND
GND
6
DSR
–
–
7
RTS
–
–
8
CTS
–
–
9
–
–
–
