- 4 -
AC-DB9-I Models
AC-RJ45 Models
Reset Button
—
Press the Reset button continuously for 5 sec to load
factory defaults
The reset button is used to load factory defaults. Hold the reset button
down for five seconds using a pointed object such as a straightened
paper clip. Release the reset button when the Ready LED stops blinking.
LED Indicators
Name Color Function
PWR 1,
PWR 2
Red
Power is being supplied to the power input
Off
Power cable is not connected
Ready Red
Steady on: Power is on and the unit is booting up
Blinking: IP conflict, DHCP, or BOOTP server did not
respond properly, or a relay output occurred
Green Steady on: Power is on and unit is functioning
normally
Blinking: Unit is responding to the locate function
Off
Power is off, or power error condition exists
Tx
Green Serial port is transmitting data
Rx
Amber Serial port is receiving data
LAN 1,
LAN 2
Green Indicates 100 Mbps Ethernet connection
Amber Indicates 10 Mbps Ethernet connection
Off
Ethernet cable is disconnected
Hardware Installation Procedure
STEP 1:
After unpacking the unit, use an Ethernet cable to connect
the unit to the network.
STEP 2:
Connect your device to the desired port on the unit.
STEP 3:
Place or mount the unit. The unit may be placed on a
horizontal surface such as a desktop, or mounted on the wall.