- 4 -
Hardware Installation Procedure
1.
Connect the MGate 5119's terminal block to the power supply,
which could provide 12 to 48 VDC.
2.
Use a serial or Ethernet cable to connect the MGate to the Modbus
RTU/ASCII/TCP, DNP3 Serial/TCP, IEC60870-5-101/104 device.
3.
Use an Ethernet cable to connect the MGate to the IEC 61850 MMS
system.
4.
The MGate 5119 is designed to be attached to a DIN rail or
mounted on a wall. For DIN-rail mounting, push down the spring
and properly attach it to the DIN rail until it “snaps” into place. For
wall mounting, install the wall-mount kit (optional) first and then
screw the device onto the wall. An M3 screw is suggested, and the
minimum length of the screw should be 10 mm.
The following figure illustrates the two suggested mounting options:
The following figure illustrates how to attach screws to the mounting
kits:
DIN Rail:
