C320Turbo/PCIEL
Hardware Installation
2-3
Installing the CPU and UART Modules (Desktop)
Step 7: Connect the Intellio C320Turbo/PCIEL Control Board to the CPU Module with the shipped DB25 to
DB25 cable as shown in the following picture.
If range extension or external power is required, please use the 10-pin cable that is included with the
long range extension kit instead. There are two types of installations: without power adapter and
with power adapter, which are described below.
Without power adapter
In most cases, you will not need a power adapter.
A: Set the CPU Module power switch to the OFF position. This is absolutely necessary when
installing or removing the cable, the CPU Module, or the UART Module(s). Power should not be
switched on until you have installed all components.
B:
Connect the card power socket to the PC power supply with an IDE power cable.
C: Plug the DB25 (male) of the 25-pin cable into the connector on the rear panel of the Intellio
C320Turbo/PCIEL Control Board.
D: Plug the DB25 (female) cable into the CPU Module.
E: Replace the system cover.
With power adapter (for range extension/external power application)
In case of range extension or external power requirement, you will need a power adapter.
A: Set the CPU Module power switch to the OFF position. This is absolutely necessary when
installing or removing the cable, the CPU Module or the UART Module(s). Power should not be
switched on until you have installed all components.
B: Plug the DB25 (male) connector of the 10-pin cable into the connector on the rear panel of the
Intellio C320Turbo /PCIEL Control Board.
