MOVIN
COOL
24HFU / 24HFU-1 SERVICE
PAGE 5
CONSTRUCTION AND SPECIFICATIONS
2-1.
Basic Construction
The MovinCool Spot Cooling System is compact
in construction because the condenser and the
evaporator are enclosed in one unit. The interior
is divided into three sections. The upper front
face is equipped with the evaporator, while the
lower front face contains the drain tank. The
rear section contains the condenser, the com-
pressor and the control box.
2-2.
Air Flow
Air drawn from the right side face passes
through the condenser and extracts the heat.
This hot air is blown out through the upper
exhaust air duct. Air taken in from the front face
is cooled by the evaporator and then blown
through the cooling air duct which can be turned
in any direction. All the air inlets are provided
with filters, while the exhaust air duct is pro-
tected by wire mesh.
■
Air Flow
2-3.
Compressor and Fans
The compressor is hermetically sealed. One
motor is used with two centrifugal fans to draw
air across the evaporator and condenser.
2-4.
Drain Tank
The capacity of the drain tank is 5.3 gallons (20
liters). The unit is equipped with a full tank lamp
and a device to automatically stop the unit’s
operation when the drain tank reaches a level of
approximately 4.4
±
0.5 gallons (16.5
±
2 liters).
