Movi 1000010212, User Manual, Page: 59 / 67

Troubleshooting Guide
G mba Won’ Tu n On
Possible Cause Possible Solution
Batteries are discharged Replace discharged batteries with fully charged batteries
Batteries are damaged Replace all damaged batteries
Dispose of damaged batteries properly
Batteries unplugged or connections
not seated properly Check that the battery connections are properly seated
G mba ‘On’ Bu No S ab z n One o Mo e Axes
Possible Cause Possible Solution
Axis Stiffness is set to 0 Use GCU Display or Mobile App to raise the stiffness values on
axes with (0) stiffness
Dual Operator Radio Controller is in
Kill Mode Use the Mode Switch on the Radio Controller to activate Dual
Operator Mode
Gimbal is still initializing Make sure the gimbal is steady for 5 seconds
Gimbal is in sleep mode Tap the ‘Power’ button on MōVI Carbon twice to take MōVI
Carbon out of sleep mode.
Ho zon (Ro Ax s) Is No Le e
Possible Cause Possible Solution
Roll Trim set to Adjust the Roll Trim setting to achieve a level horizon
Ho zon (Ro Ax s) Is No Le e Unde A e e a ons
Possible Cause Possible Solution
IMU not fully warmed up Wait 400s (6min) for the IMU to fully warm up before subjecting
MōVI Carbon to high accelerations.
No on o n Dua Ope a o Mode
Possible Cause Possible Solution
Dual Operator Radio Controller is off,
or set to Kill or Majestic Mode Turn on Radio Controller and set Mode Switch to Dual Operator
(DUAL) Mode
Radio Controller Mapping is
misconfigured If you are using a Spektrum DX7, ensure that the Radio
Mapping settings in the GUI are correctly mapped. (Refer to the
Dual Op Mode Configuration section)
| OPERATION MANUAL | 950-00074 58