9
MC12 manual
6
Operation
The Interface
General
•
Connect motor before switching on the controller
•
ALL changes
has to be entered
to acknowledge.
•
A blinking value means the changed data is not acknowledged.
•
To cancel a changed value, press the specific function button (
or
) again.
•
Most functions have a designated key and LED on the interface. When a function is activated the LED
of that key/function will light up.
•
All functions except the test
function can be activated if the unit is started, (dependent on the
chosen configuration.)
•
Only one of the following functions
,
, can be active at the same time. This means no other
function can be activated before the active function is deactivated
The unit can be set to different configurations, see paragraph 7.3.
Increase / Decrease value
Set dosing speed [RPM]
Set dosing time [sec.]
Start LED:
Blinking:
motor
standby / waiting on
start signal.
Lighted continuously:
motor is running.
Start system
Stop system
Run test
Confirm value
Alarm LED
Input LED. Is lighted when
input connection is made.
