Mountfield SP533, Operating Instructions Manual, Page: 18 / 20

Figure 12
18
Figure 11
Adjust the tension of the belt with the nut (1) to get the right measurement (6 mm)
(Figure 12).
1
1
6 mm
BEFORE EACH USE
Always ensure that the mower is in a safe working condition. Inspect the cutter blade for damage; check safe-
ty devices and guards; check that all nuts, bolts and screws are secure.
Check the oil level as follows:
a) Remove the oil filler cap and wipe the dipstick clean (Figure 11)
b) Refit the dipstick into the filler neck without screwing it down.
Remove the dipstick and check the oil level; oil should be at the FULL
mark. The oil tank capacity is about 0,55 litre or 20 fluid oz.
c) If the oil level is low add Mountfield oil part number MX855 or a
SAE 10W-30 oil, to the upper limit on the dipstick. Do not overfill; the
oil level should not be above the FULL mark.
Fill the fuel tank with unleaded petrol. Do not overfill; the level should
be below the bottom of the fuel tank neck.
Stop the engine and disconnect the spark plug lead before working on the machine.
MAINTENANCE
DO NOT TIP THE MOWER ONTO ITS SIDE AS THIS WILL FLOOD THE AIR FILTER WITH OIL.
To access the underside of the machine, lift the front wheels by lowering the handle until it rests on the
ground.
CUTTER BLADE
Examine the cutter blade regularly for wear or damage.
A slightly worn blade can be re-sharpened by your local dealer
If the blade is damaged it should be replaced. Replacement blade kits are available from your Mountfield sto-
ckist. If in doubt refer to your dealer, or telephone 0845 600 2912.
Blade must always be marked with part number 81004459/0
CLUTCH CABLE ADJUSTMENT
Make sure that the clutch lever is fully released.
Engage the clutch lever and check that the rear wheels lock when the
mower is pulled backwards
Start the mower and ensure it does not drive when the lever is disengaged.
ENGINE
An engine Manufacturer’s Owner’s Manual is supplied with your mower.
Please read this, it provides detailed information on engine operation, maintenance
and battery care. Repair work other than routine maintenance, should be carried out
by an authorised dealer.
STORAGE
A little time spent on your mower after use will ensure many years of reliable mowing.
To access the underside of the cutter deck, ensure that spark plug lead is disconnected. Then lift the front wheels
by lowering the handle until it rests on the ground. Do not tip the mower onto its side, as this will flood the air filter
with oil.
AFTER EACH USE
Remove any grass pulp from the underside of the cutter deck using a non-metallic instrument such as a piece
of wood. Take care not to damage the paintwork.
Examine the cutter blade for any damage. A damaged blade may upset the balance of your mower and cause
excessive vibration. If in doubt refer to your dealer.
Inspect the grass collector and clean it if necessary. If the mesh becomes clogged airflow will be reduced and
impair grass collection.
The handle can be folded down to reduce the amount of storage space required. Take care not to trap any of
the operating cables when folding or unfolding the handle.
Store the mower in a clean, dry area well away from any naked flames, sparks or heat source.
MAX
MIN