Mountfield PATRIOT 5T, Translation Of The Original Instructions

Page: 30 / 34

30
Reposition the log on the main frame and repeat the
splitting process, or put the log to one side.
How to release a jammed log?
1. Loose the operating lever as well as the operating
pushbutton that the log ram can go back.
2. Place a small wooden(width 120mm)between the log
and ram and then move the log raw forward so that
the jammed log can be split completely
3. If the log is not released, keep repeating this procedu-
re, using larger chocks, until the log is released.
Never use a hammer to release a jammed log, and
keep your hands away from the log.
Do not enlist the aid of a second person - this is
a one-man job.
If the log is not released, keep repeating this proce-
dure, using larger chocks, until the log is released.
• Finishing work:
 Attend to that the log ram has gone back to its basic
position.
 Then remove the plug from the power socket.

Close the bleed screw.
 Follow the care and maintenance instructions.
Care and maintenance
Remove the plug from the power socket before starting
any maintenance or cleaning work.
Wear protective gloves in order to avoid injury to
the hands.
Observe the following in order to keep the log splitter in
good working order:
• Clean the machine thoroughly after you have fi-
nished using it.
• Remove any resin remains on the machine.
• Oil the piston rod regularly with an environmenta-
lly friendly spray oil.
• Check the oil level and change the oil as necessary.
Sharpening the splitting wedge
After extended periods of use, or if the splitting per-
formance is reduced, sharpen the splitting wedge with
a file (and remove any burrs).
How do I check the oil level?
1. The log ram must be in its starting position.
2. Stand the log splitter on end, with the filler opening at
the top.
A second person will be required to up-end and
hold the log splitter.
3. Unscrew the dipstick. Do not drop or lose the oil seal
when removing the dipstick.
Disassemble this part
Dipstick
4. Clean the dipstick and the oil seal.
5. Replace the dipstick fully into the oil reservoir.
6. Now remove the dipstick again, and read off the oil
level.
– If the oil level is between the two marking on the dips-
tick, there is sufficient oil in the reservoir.
– If the oil level is below the lower marking, more oil
should be added with the aid of a clean funnel.
Lower marking Upper marking
7. Check the oil seal and replace it if it is damaged in any
way.
Oil seal
8. Replace the dipstick and screw it firmly into place.
Caution! Do not tighten the screw too tightly, since this
may damage the oil seal or the thread in the cylinder
cover.
Sharpen wedge