6
11.
Install your ESC and Receiver in the fuselage, as shown below. Mount them fairly far forward in the fuselage. Use
Velcro or double sided tape. Secure the hatch in place with clear tape front and back. Fold over part of the tape on
the back, so you can remove it easily when changing the battery.
12.
Mount your battery where it is needed, to balance the plane at 3.0” in front of the carbon spar, as shown below.
13.
Set the control throws for 22 degrees (1.0” each way) on high rates, and about 16 degrees (0.75” each way) on
low rates. 50% to 60% expo in nice to have on high rates to smooth out the control near the center.
14.
Launch your model by holding onto the fuselage top, just behind the cockpit area, giving it about ¾ power and
lightly tossing it into the air. As with most jets, you will need a little power for full control in slow and high alpha
flight. If control gets mushy, add a burst of power.