Important:
Check both plastic tri-knobs have been tightened after
adjusting your handle.
Care must be taken with your rubber grip handle as this
is not covered for damage of wear and tear under the
warranty.
WRIST STRAP
This is wrapped around the handle
Warning:
We recommend that the wrist strap be used at all times
during operation of the buggy. This joins you and the
buggy together providing safety and control.
SUNHOOD
The sunhood is fixed into position by tightening the
large tri-knobs to the side of the buggy. This prevents
the sunhood from involuntarily folding back when in
use.
NOTE: Do not over tighten.
Loosen tri-knobs when folding your sunhood back.
USE OF THE SLING
Important:
We recommend using a baby insert to support the in-
fant’s head.
Toddler in recline and upright position suitable for chil-
dren 4 months onwards.
RAINCOVER
This fits over the sunhood when folded down.
The raincover has straps on both sides, these are
wrappeda round the tri-knobs for the sunhood.
Dome the raincover to the front of the footplate.
Important:
The raincover is shower proof only – we recommend
using your raincover for only short intervals in heavy
rain.
SUNMESH/INSECT NET
This connects to the sunhood by zips on both fabric
parts.
Dome sunmesh to the front of the footplate.
The sunmesh has a 65% ultra violet shade factor.
Important:
Do not use the sunmesh as the only protection for your
child from the sun.
Protective clothing should also be worn and the appro-
priate sunshield applied.
FABRIC CARE
To keep the fabric looking fresh and new it should be
washed occasionally before substances such as dirt
and grime are allowed to accumulate and become
embedded in the fabric.
Spills should be mopped up immediately as they oc-
cur.
Brush off any loose dirt then clean with a mild solu-
tion of natural liquid soap or sunlight soap in luke-
warm water.
Rinse thoroughly to remove soap.
NOTE:
DO NOT use detergents.
Allow to air dry naturally – DO NOT place in a
dryer.
CARE AND MAINTENANCE
There are three steps to cleaning your powder coated
buggy and chrome frame.
Remove loose deposits with a wet sponge rather than
risk micro scratching the surface by dry dusting.
Using a soft brush and a mild detergent in warm wa-
ter, clean the powder coating and chrome to remove
any dust, salt or other deposits.
Always rinse thoroughly with fresh water to remove
any remaining detergents.
Warning:
The use of harsh solvents may damage the powder
coating on the frame.
For the frames only, Dulux recommend Methelayted
spirits for stubborn stains.
BUGGY MAINTENANCE
The chrome sliding arms, extendable handle, axles,
nuts and bolts can become stiff and squeaky over
time.
This usually occurs from the accumulation of air-
borne salt deposits, atmospheric pollution, general
dirt, grime and ultra violet light.
Follow the instructions shown above for the “three
step” cleaning programme.
After cleaning the chrome parts, spray a light coating
of CRC/Silicone spray or equivalent onto the affected
area.
Important:
Remove fabric while performing buggy maintenance.
TYRES
Maximum recommended inflation pressure 30 P.S.I.
Size of tyre tube 12.5 x 2.25. (62-203).
Important:
Care must be taken with your tyre and tyre tubes.
Keep tyres inflated to recommended tyre pressure to
ensure effective operation of the brake.
There is no cover under the warranty for damage
done to tyres and tyre tubes due to wear and tear
