6
4. Installing Arm Brackets Onto The Back of Your Display:
Once you locate the appropriate screws, a ach the two
arm brackets to the back of the display. To a ach the arms
use the proper bolt and washer for each of the four
moun ng holes. In the event your display has recessed
holes or a curved back, your hardware pack includes
plas c spacers to fill the gaps. These plas c spacers are
not necessary for most installa ons.
3.
A aching The Mount to Your Wall:
Once the four
holes are pre-drilled, affix the wall plate to the wall
with all four lag bolts and washers into the wall. The
included plas c anchors DO NOT need to be used for
wood stud installa on.
Note on loca ng hardware to mount arms to your
display:
If your display does not come with the
moun ng screws in the back of the display, check the
original desk stand as in some cases the same screws to
hold the desk stand are used also to mount your
display. If neither of these op ons work, the hardware
pack included with your mount contains several of the
most common sized screws for moun ng your arm
brackets to your display.
5. Adjus ng The Rota on:
The rota on adjustment allows the TV to remain level when the TV is pulled out or flat against
the wall. To u lize this adjustment there are four bolts in the center of TV plate which must be slightly loosened to rotate
the display from side to side.
