Feeder
Circuit Board
Motor
Receiver
Battery
MFHP53863 • 08272021
MOUNTING RECEIVER
D
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
For devices approved under Part 15, the user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user about changes or modifications to the device (Section 15.21).
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
To activate the Feeder motor for a period of five seconds, hold the Activation Button until the Feeder runs.
CHECKING CONNECTIONS
C
Our Service Department will gladly answer any questions you have.
www.moultriefeeders.com/support
Connect the battery to the Feeder and then to the Receiver.
Connect the Red Wires to the positive terminal (+) and the
Black Wires to the negative (-) terminal.
Remove the protective cover from the double sided tape on the back of the Receiver. Position the Receiver on a
clean and dry location inside the Feeder.
Route the black Antenna Wire inside the plastic Feeder enclosure. The Antenna Wire should not be folded or in
contact with the motor. If using the Feeder Activator in a metal Feeder enclosure, the Antenna Wire must be
routed outside the box in an area that is not accessible by varmints.
OPERATING UNIT
E
Status Light
The Status Light will blink once if it is connected to the
battery properly.
Press the button on the remote and the motor will turn.
If the light does not blink and your motor does not spin
when the transmitter is pressed, swap the wire connections.
WIRING THE RECEIVER - MOULTRIE FEEDER KIT
B2
If installing on a Moultrie feeder kit, locate the separate
wires labeled
“Feeder Activator Conn/-”
as
shown in the photo. Use the steps from
Section B1
to
install the receiver wires onto these activator wires.
This will prevent you from compromising the wires that
run between the timer circuit board and the the motor
on your feeder kit.
MFHP53863_Feeder Activator_MANUAL_ENGLISH_8-27-21.indd 2
MFHP53863_Feeder Activator_MANUAL_ENGLISH_8-27-21.indd 2
8/26/21 2:39 PM
8/26/21 2:39 PM
