MOTORIZED ELECTRONIC LOCK
BATTERY CHARGER
99.711
GENERAL INSTRUCTIONS
This manual is intended for technically qualified and trained installers.
Mottura Serrature di Sicurezza S.p.A. thanks you for choosing this device and reminds you as follows:
- Read the instructions very carefully before installing or doing any maintenance on the device.
- All assembly and connection procedures must be done according to Rules of Good Engineering as well as in conformity to law.
- DO NOT install this device in explosive environments or atmospheres or in the presence of flammable fumes/gases.
- DO NOT install this device on a door with risk of contact with water or atmospheric agents unless the door is adequately protected.
- Always disconnect the power supply and isolate all parts before installing or during any maintenance on the device. Take all possible precautions to
eliminate the risk of electrical shock when during the installation and/or maintenance procedures described in this manual.
- Protect the battery charger before any work on the door that could produce scrap (welding, drilling, etc.) that might get into the charger and damage it.
- The installer must give these instructions and all maintenance instructions to the user.
- Keep these instructions for future use with sales receipt to validate the warranty.
- In case of problems, contact your authorized dealer only.
Mottura Serrature di Sicurezza S.p.A. may change the characteristics of the products described in these instructions at any time and without notice.
WARRANTY TERMS
This device has been inspected by Mottura Serrature di Sicurezza S.p.A. and is guaranteed against all manufacturing defects for the period defined by
Italian law; the period begins on the date of purchase as demonstrated by the sales receipt. The warranty is effective if the sales receipt, bearing infor-
mation identifying the device, is shown to the dealer or service personnel. The warranty covers the replacement or repair of parts found defective due
to faulty manufacture; shipping costs to and from service centers are charged to the customer.
In case of a repeated malfunction of the same origin or a malfunction that cannot be repaired, Mottura Serrature di Sicurezza S.p.A. may decide, in its
final judgment, to replace the entire device. The warranty on the replacement device will continue to the expiration of the original device. If the device
must be serviced at the customer’s home, the customer is required to pay (if requested) a minimum charge to cover the transfer costs of authorized
service personnel.
Transport is at the customer’s risk if the customer ships the device, and at the service personnel’s risk if the device is picked up and transported by service
personnel.
LIMITS OF LIABILITY
The warranty does not cover damage deriving from:
- negligence, carelessness, or use other than as described below
- failure to protect the device before doing any procedure that may generate scrap or waste (welding, drilling of panels, drilling of structure, etc.) that
prevents its correct functioning
- maintenance work not conforming to these instructions or done by unauthorized personnel
- use of accessories/components that are not original Mottura products
- shipping of the device without the necessary precautions
- any circumstances not attributable to manufacturing defects.
Operating temperature: -10°C to +40°C.
In addition, Mottura Serrature di Sicurezza S.p.A. declines all liability for any harm to persons or damage to property deriving from failure to comply with
all of the instructions and warnings contained in this manual.
RECHARGEABLE
