ZU25201e_e.doc / Sep-13
Page 15 / 36
6. Setup Procedure
For all basic applications you can use the Teach feature for commissioning of the unit.
Extended functions need a PC for setup and are described under section 8.
As a first step it is advisable to check the input pulses by means of the LED marked “Status”.
Position 6 of DIL1 must be set to ON for this test.
When you press the TEACH button one time, the yellow LED will be lit after the unit detected a
pulse on input A. The LED will be OFF when no input pulse has been detected.
When you press the TEACH button once more, you can also check input B (if applicable). With
use of mode A+B and two independent impulse sources, again the yellow LED will be lit after a
pulse has been detected on input B.
