BRAKE LEVER
KICKSTAND
THROTTLE
CHAIN TENSIONER
BRAKE MECHANISM
SPRING-LOADED FOOT PEGS
OIL FILL CAP
The Brake Lever is used to apply braking to the rear
wheel. When you pull the lever back, braking power
is applied to the rear wheel. The harder it is pulled, the
more braking power is applied to the wheel. To release
the front brake, release the front brake lever.
The kickstand is used to keep the mini bike upright
when not in use. It is located on the left side of the
mini bike and can be swung down with your foot and
then the bike leans on it for support.
It is very important to remember to
swing the kickstand up and out of the way when
riding or accidents can occur.
When operating your MBx11 there are some key operating controls that allow you to
operate your mini bike. Their location and operation information is shown below.
1. Brake Lever 2. Throttle 3. Folding Foot Pegs 4. Oil Fill Cap
When operating your MBx11 there are some key operating controls and components
that allow you to operate your mini bike and perform routine maintenance.
Their location and operation information is shown below.
1. Kick Stand 2. Chain Tensioner 3. Brake Mechanism
The Throttle controls the speed of the engine and is
located in the right grip on the handlebars. To increase
the engine speed, twist the throttle grip toward you,
or downward. To decrease the engine speed, twist
the grip away from you, or upward. The throttle grip is
spring loaded so it will return to the lowest position as
you release it.
The Chain Tensioner is used to keep the proper tension
on the drive chain and is located on the frame, next to
the chain guard. You should have about a half inch of
play in the longest part of the chain, if not, loosen the
set screw and turn the nut clockwise to tighten and
the opposite direction to loosen. Then tighten the set
screw back up to hold the tensioner in place. See page
24 for more details on chain maintenance.
Your MBx11 mini bike is equipped with a rear disc
brake. The brake provides the stopping power to bring
the mini bike safely to a stop and to hold it at a stop
when the engine is running and the bike is trying to
move forward. Refer to the Maintenance Procedures
section for brake adjustment instructions.
The MBx11 is equipped with spring-loaded foot pegs
which allows them to flip out of the way when they
strike an object and reduces the chances of them
being damaged. The foot pegs flip backward and up,
toward the rear of the mini bike. The spring action
allows them to flip back into position automatically.
The Oil Fill Cap is a very important component to know
and understand. It is equipped with a dipstick and is
used to check the oil level in the engine. If the oil level
is not maintained properly, the engine can fail prema-
turely and cause costly repairs.
OPERATING CONTROLS
OPERATING CONTROLS
9
8
OPERATING CONTROLS
Brake Lever
Kickstand
Throttle
Chain
Tensioner
Disc
Brake
Roller Axle Bolt
Folding Foot Peg
Oil Fill Cap
TROUBLE
?
DO NOT RETURN TO STORE
contact us!
888-488-MOTO (6686)
or email [email protected]
Summary of Contents for MBX II
Page 22: ......
