3
Do not operate your Electric Skateboard in crowded areas.
NOTE:IF YOU DO NOT UNDERSTAND ANY AND ALL PARTS OF THIS SAFETY
OPERATION INFORMATION,PLEASE CALL SKATEBOARD WARRANTY SERVICE
TO CLARIFY ALL POINTS IN THIS OWNER’S MANUAL.
RIDING INSTRUCTIONS
Before riding your new Electric Skateboard,please be sure you fully understand how the
model you have purchased operates.
IMPORTANT
The Electric Skateboard wireless remote uses a unique close proximity low frequency radio
signal that minimizes the possibility of signal interference.Signal interference occur with
other Electric Skateboard using the same frequency,high power lines,cell phones or other
signal emitting devices.Use cautioin and check your ride area for signal interference before
use.
ELECTRIC SKATEBOARD
Power Hand Grip Controller
1.
The Power Hand Grip Controller regulates the speed of the board.Pulling back on the
lever,the board will cause acceleration.Releasing the lever will return it to the neutral
position.Pushing forward on the lever will initiate braking force.
2.
After standing on board,pull the power lever.Your Electric Skateboard will slowly and
build speed as you hold the lever back.
3.
To decrease speed,let the lever go.This will slowly decrease your speed.To slow
quicker,push the lever forward to brake.Maximum speed and stopping distance depends
on your weight and riding surface.
4.
Know your limits.Start slowly and keep your speed down until you have mastered
controlling your Electric Skateboard.
5.
Read the section titled:”Riding your Electric Skateboard before attempting to ride.”
THROTTLE/BRAKE SAFETY WARNING
The Electric Skateboard is a powerful device,if you step on and pull the power lever,you
could be quickly(engaging the brake)could THROW YOU FORWARD FROM THE
BOARD.KNOW YOUR LIMITS AND USE THE POWER HAND GRIP CONTRROLLER
ACCORDINGLY.THESE IS A MOMENTARY TIME LAG FOR POWER AND BRAKE
ACTIVATION.
Hand Controller Battery
The hand controller uses a standard 9-volt alkaline battery.Switching the controller off when
not in use will maximize battery life.If you notice unreliable communication with the
board,the battery should be replaced.
Power Switch
The Electric Skateboard is equiped with an ‘ON/OFF’ switch on the side of the battery box on
your board.To start the Electric Skateboard,turn the switch to the ‘ON’ position.Make sure to
turn the board to the ‘OFF’ position when not in use.Leaving the switch in the ‘ON position
when not in use may damage the electronics and battery.
