9
INSTALLATION
TIPS
When installing the GPS Module to work with your TV or MESA system it must be placed in a location
that can give it an unobstructed view of the sky.
DO NOT
•
Do not place the GPS Module under the dish or any object that can block the GPS signal
reception from the satellites.
•
Do not place in a location subject to standing water.
•
Do not install the splitter where water damage could occur.
DO
•
Protect all outside coax connections from moisture using a form of dielectric grease.
•
Secure all coax connections properly.
•
Read all instructions before beginning.
ERROR CODES
Nomad SD/SD2
•
If the controller is configured for SHAW Direct and no GPS detected is detected upon POWER
UP sequence the
FIND LED will blink 22 times
and repeat indicating “No GPS Detected”.
Probable Cause
1.
Splitter installed improperly
-
Refer to Installation Diagram
2.
Splitter bad
-
Check for voltage at the GPS/Mount
3.
No GPS installed
-
Contact installing dealer
4.
GPS not connected to Nomad
-
Refer to Installation Diagram
5.
GPS is bad
-
Replace GPS
•
If the controller is configured for
other
than SHAW Direct then the above still applies. SHAW
Direct software version 1000 and above
requires
that a GPS be installed.
Summary of Contents for 213-GPS-002
Page 10: ...10 Sample TV Installation...
