T200I EN IN.2 UG .indd 24
15/05/2019 09:13
M
M
M
M
M
M
M
M
M
M
M
M
M
M
6.
Base settings
6.1
Change base PIN code
Some functions are protected by a 4 digit PIN code which must be entered if
you want to change the settings. The default PIN is 0000. You can change this
to your own preferred number.
When you enter a PIN, the digits are shown as ****.
1.
Press
, scroll
d
to
SETUP
and press
.
2.
Scroll
d
to
PIN CODE
and press
.
3.
The display shows
PIN ?
.
4.
Enter the old PIN (default setting = 0000) and press
.
5.
The display shows
NEW PIN
. Enter the new PIN and press
.
6.
The displays shows
RETYPE
. Re-enter the new PIN and press
to confirm.
Important
If you change the PIN code, please keep a record of the new number.
6.2
Tone / Pulse dialling
Your T2I is set to tone dialling. You should only need to change this if
connected to an older type of switchboard / PABX which requires pulse
dialling.
1.
Press
, scroll
d
to
SETUP
and press
.
2.
Scroll
d
to
DIAL MODE
and press
.
3.
Press
u
or
d
to select
TONE DIAL
or
PULSE DIAL
and press
to confirm.
6.3
Flash
This setting is useful to access certain network and PABX/switchboard
services.
The default flash time is suitable for your country and network operator. It is
unlikely that you should need to change this setting unless advised to do so.
1.
Press
, scroll
d
to
SETUP
and press
.
2.
Scroll
d
to
FLASH
and press
.
3.
Press
u
or
d
to select
FLASH 1
(short flash time) or
FLASH 2
(long flash
time) and press
to confirm.
Note
You may need to use the Flash function if you are connected to a switch.
Contact your PABX supplier for further information.
24
Base settings
Summary of Contents for T201I Series
Page 41: ... This page has intentionally been left blank T200I EN IN 2 UG indd 41 15 05 2019 09 13 ...
Page 42: ... This page has intentionally been left blank T200I EN IN 2 UG indd 42 15 05 2019 09 13 ...
Page 43: ... This page has intentionally been left blank T200I EN IN 2 UG indd 43 15 05 2019 09 13 ...