Motorola SYMBOL DS6707, Product Reference Manual

Page: 171 / 424

Chapter 10 Symbologies
Introduction
This chapter describes symbology features and provides programming bar codes for selecting these features.
Before programming, follow the instructions in
Chapter 1, Getting Started .
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when you power down the digital imager scanner.
Select a host type (see each host chapter for specific host information) after the power-up beeps sound. This is
only necessary upon the first power-up when connecting to a new host.
To return all features to default values, scan the Set Default Parameter on page 4-4 . Throughout the programming
bar code menus, asterisks (
*
) indicate default values.
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to transmit bar code data without the
UPC-A check digit, simply scan the Do Not Transmit UPC-A Check Digit bar code under Transmit UPC-A Check
Digit on page 10-17. The digital imager scanner issues a fast warble beep and the LED turns green, signifying a
successful parameter entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes. See the individual
parameter, such as Set Length(s) for D 2 of 5, for this procedure.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
*
Enable UPC-A
(01h)
Feature/Option
*
Indicates Default
Option Hex Value for
programming via SSI command