Installing the Gateway
B
SVG7782 Wireless Voice Cable Modem Gateway
•
User Guide
6
591429-001-a
This document is uncontrolled pending incorporation in a Motorola CMS
4.
Connect the other end of the Ethernet cable to the Ethernet port on your computer.
5.
Plug the telephone cord of a single or two-line telephone into the Tel 1 port on the gateway.
Note
: For two-line telephones, use the Tel 1 port.
6.
Plug the other end of the telephone cord into the telephone.
Note
: You must contact a VoIP service provider to activate the telephone service.
7.
For a second telephone, plug the telephone cord of a single-line telephone into the Tel 2 port on the
gateway.
8.
Plug the power cord into the Power port on the gateway.
9.
Plug the other end of the power cord into an electrical outlet. This automatically powers ON the
gateway.
Note
: The first time you plug in the gateway, allow from 5 to 30 minutes for the gateway to scan and
connect to the appropriate communications channels.
Testing the Gateway Connections
Perform the following gateway connectivity test to verify that all the components were connected
properly:
1.
Power ON your computer and then log on.
2.
Check that the POWER, RECEIVE, and SEND front panel LEDs on the gateway first FLASH in
sequential order and then light SOLID. See
for additional LED status information.
If an LED did not light SOLID, contact your service provider for assistance.
3.
Contact your service provider to activate (provision) the gateway.
Note
: Your service provider may allow for automatic activation which will automatically launch a
special website when you open a web browser.
4.
Once your gateway is provisioned, open a web browser on your computer, such as Internet Explorer,
Firefox, Google Chrome, or Safari.
5.
Type a valid URL (for example,Enter
.
If the web page did not open, contact your service provider for assistance or proceed to
to manually set up the network options on your computer.
Setting Up an Internet Connection
IMPORTANT!
Your computer may already be configured to automatically connect to the
Internet. If so,
do not
change the network options before contacting your service provider
for assistance.
If you cannot access the Internet after completing the gateway installation, you may have to manually set
up your computer to connect to the Internet. To do this, you will have to enable the network options on
your computer to automatically obtain an IP address and DNS server address.
Please note, operating system-specific commands for configuring computer network options are not
provided in this document. The general steps provided below can be used for the following Microsoft
Windows platforms:
•
Windows 8
DRAFT
