Motorola SE3300, Integration Manual

Page: 50 / 74

5 - 6 SE3300 Integration Guide
AIM_POWER 0xF3
Controls the brightness of the aiming pattern. The default is 0x0 or Always On.
A value of 0x0 indicates that exposure and readout times control the aim's duration (and power or brightness).
Values of 0x1 - 0xFF indicate the aiming duration increments from 0.5 ms upward in 0.5 ms intervals; however,
exposure and readout times clip its maximum value.
AUTO_POWER_REDUCTION 0x74
Places the SE3300 in a low power state when idle for the duration of time specified by the
TIME_TO_LOW_POWER command. Any I
2
C command wakes the SE3300 from low power mode.
The SE3300 is considered idle only if acquisition is stopped. While acquisition is started, the SE3300 does not
automatically enter low power mode.
ENTER_BOOTLOADER 0x91
Enters bootloader mode, which changes the SE3300 protocol so that it no longer supports this command set.
Bootloader mode is required for firmware update.
EXEC_INLINE 0x83
Executes more than one command inline without first writing it to the engine. This is helpful for scripts that don't
require executing more than once.
Example
To execute inline with Aim On, Illumination On, and Acquisition On the command is:
<0x83><0x00><Len><C1Len><C1Op><C1Data><C2Len><C2Op><C2Data>
<C3Len><C3Op><C3Data><CS>
or
<0x83><0x00><0x09><0x02><0x55><0x01><0x02><0x59><0x01><0x02><0x58><0x01><0x70>
EXECUTE_SCRIPT 0x77
After programming a script (via the WR_SCRIPT command), use this command to execute it.
EXTERNAL_ILLUMINATION 0x5
A
Controls operation of the EXT_ILLUM_EN signal on the SE3300 host connector.
FRAME_RATE 0x5E
Sets the SE3300 frame rate.