Getting Started
13
EN
G
L
ISH
1.
Connect the small plug of the power adapter to the Owner unit and
the other end to the electrical outlet. Only use the enclosed power
adapter (6V DC/500mA).
2.
Press and hold the
P
POWER ON/OFF button for 1 second to
turn ON the Owner unit.
3.
Once the Pet and Owner units are switched on, the display on the
Owner unit will show the video captured by the Outdoor Pet Unit.
4.
If there is no connection or you are out of range, the video display
will go off and
will be shown on the LCD display, and the unit will
beep every 5 seconds. Move the Owner unit closer to the Outdoor
Pet Unit until the link is re-established.
5.
Press and hold the
P
POWER ON/OFF button, until the progress
bar finishes scrolling, to turn OFF the Owner unit.
NOTE
The battery icon
0
turns RED to indicate that the battery is low, and it
gives a beep every 16 seconds. The battery needs to be recharged. The
battery pack takes about 16 hours to be fully charged.
When charging
1.
During power OFF, when adapter is plugged in, an adapter logo will
display on screen and then a flashing battery logo will display for
45 sec. The Blue LED at top left corner light up indicates that the
adapter is plugged in.
2.
During power ON, when the adapter is plugged in, the battery icon
on screen's top right corner will show that the battery is charging.
The Blue LED at the top left corner lights up to indicate that the
adapter is plugged in.
2.3
Outdoor Pet Unit Installation
IMPORTANT
• This product is not intended for submersion in water. For outdoor use,
mount it in a sheltered place where it is not directly exposed to rain or
snow.
• Determine a location for the Pet Unit that will provide the best
