Motorola RDM series, User Manual, Page: 56 / 78

ADV
ANC
ED
CONFIGU
R
A
T
ION
English
48
Configuring a Frequency
Assuming current frequency value is set up to
channel 1, with the MURs default frequency “1”
(equivalent to 154.60000 MHz), and it will be
changed to Frequency Number = “4” (which is
mapped to 151.88000 MHz), follow the
sequence below:
1. Enter Advanced Configuration Mode.
2. Short press the PTT button to enter Frequency
Mode. Radio will signal current value “1” with
one beep (a red blinks).
3. Press the SB1 button once to increase digit to
“2” (two beeps & two red blinks).
4. Press the SB1 button once to increase digit to
“3” (three beeps & three red blinks).
5. Press the SB1 button again to increase digit to
“4” (four beeps & four red blinks).
6. Long press the PTT button. LED indicator will
show a green heartbeat to indicate “Idle” state.
7. Long press the PTT button to exit Advanced
Configuration Mode or turn the radio OFF.
Configuring a Code
Assuming current code value is set to factory
default “001”, and it will be changed to CTCSS/
DPL Code = 103 follow the sequence below:
1. Enter Advanced Configuration Mode.
2. Short press the PTT button three times (Enter
CTCSS/DPL Programming Selection Mode).
Radio LED will blink orange to indicate that
current value is “0”.
3. Press the SB1 button once (to change first digit
to “1”) LED indicator blinks red.
4. Short press the PTT button (to move forward
and program second digit). Radio LED blinks
orange to indicate current value is “0”.
5. Short press the PTT button and move ahead to
program the third digit. LED indicator blinks red
to indicate current value is “1”.
6. Press the SB1 button to change the ‘third digit’
to “2”. Press the SB1 button to change again
this “third digit” to “3”. The radio will signal the
chosen value.