Motorola PRO Series, Detailed Service Manual

Page: 663 / 686

UHF Band 2 (450–512/520 MHz) 25–40 W LDMOS Frequency Synthesis Section 13: 2-9
6881091C63-F
reference signal. The reference signal is generated by dividing down the signal of the reference
oscillator (Y5261 or Y5262).
The output signal of the phase detector is a pulsed DC signal routed to the charge pump. The
charge pump outputs a current at U5201, pin 43 (IOUT). The loop filter (consisting of
R5221 – R5223, C5221 – C5225, and L5221) transforms this current into a voltage that is applied to
varactor diodes CR5311 for transmit, CR5301, CR5302 and CR5303 for receive and alters the
output frequency of the VCO. The current can be set to a value fixed in the LVFRAC-N IC or to a
value determined by the currents flowing into BIAS 1 (U5201-40) or BIAS 2 (U5201-39). The
currents are set by the value of R5251 or R5252 respectively. The selection of the three different
bias sources is done by software programming.
To reduce synthesizer lock time, when new frequency data has been loaded into the synthesizer,
the magnitude of the loop current is increased by enabling the IADAPT (U5201-45) for a certain
software programmable time (Adapt Mode). The adapt mode timer is started by a low to high
transition of the CSX line. When the synthesizer is within the lock range, the current is determined
only by the resistors connected to BIAS 1, BIAS 2, or the internal current source. A settled
synthesizer loop is indicated by a high level of signal LOCK (U5201-4) which is routed to one of the
µP’s ADCs input U101-56. From the voltage the µP determines whether LOCK is active.
To modulate the PLL, the two-spot modulation method is utilized via pin 10 (MODIN) on U5201. The
audio signal is applied to both the A/D converter (low frequency path) and the balanced attenuator
(high frequency path). The A/D converter converts the low frequency analog modulating signal into
a digital code which is applied to the loop divider, thereby causing the carrier to deviate. The balance
attenuator is used to adjust the VCO’s deviation sensitivity to high frequency modulating signals.
The output of the balance attenuator is present at the MODOUT port (U5201-41) and connected to
the VCO modulation diode CR5321 via R5321 and C5325.