5
Englis
h
OPERATION
Attaching Interface Module Connector To
The Radio
1.
Turn the radio OFF.
2.
Connect the Interface Module connector to
the radio.
3.
Turn the radio ON, adjusting the audio
volume to an appropriate level.
Receiving
1.
When the Interface Module is connected to
the radio side connector, the radio’s speaker
is muted and the audio is only heard from the
audio accessory speaker.
Transmitting By Using PTT Mode
1.
Rotate the change-over switch to PTT mode
as shown in Figure 2-A.
2.
Press and hold down the Interface Module or
Remote PTT button and begin speaking in
order to transmit.
3.
Your radio will return to receiving mode when
you release the PTT button.
Transmitting By Using VOX Mode
1.
Rotate the change-over switch to VOX mode
as shown in Figure 2-B.
2.
VOX automatically sets the radio on transmit
mode, allowing hands free transmission
without pressing the PTT switch.
Beep Sound
1.
Beeps are emitted at the start / end of the
transmission. A high-pitched sound at the
start and low-pitched sound at the end.
Removing Interface Module Connector
From The Radio
1.
Turn the radio OFF before removing the
Interface Module connector from the radio.
MN000804A01_a.book Page 5 Tuesday, May 20, 2014 2:17 PM