Motorola PM1200, Basic Service Manual

Page: 98 / 138

October 26, 2007 6880309U09-A
6-44 Disassembly/Reassembly Procedures : Replacement Procedures
6. After installing the connector-unit board kit [29], assemble the radio by following the steps
outlined in 6.2.3.4.2: “PA-Unit Board Kit Reassembly” on page 6-34 .
6.2.3.6 Option Board Disassembly/Reassembly
NOTE: The two types of option boards available are: the PM1200 Quik Call II Decoder Option Board
(HKLN4346_) and the PM1200 Digital ANI Encoder Option Board (HKLN4347_). These
option boards need to be installed together with an Interface Board (HKLN4345_).
NOTE: Bracketed numbers are identical to item numbers shown in Figure 9-2. “PM1200 Radio
Exploded View” on page 9-3 .
6.2.3.6.1 Option Board Disassembly
1. Ensure all the accessory connections, power, antenna, and microphone are unplugged.
2. Using a CR-V PH2 screwdriver, remove the 7 binding head screws, M3x6 SUS B from the top
cover as shown in Figure 6-82 .
Figure 6-83. Removing Screws from Top Cover
3. Using a CR-V PH1 screwdriver, remove a taptite screw M2.6x6 from the chassis as shown in
Figure 6-84 .
Figure 6-84. Removing Screws from Chassis
2
5
1
6
7
3
4