Motorola PM1200, Basic Service Manual

Page: 84 / 138

October 26, 2007 6880309U09-A
6-30 Disassembly/Reassembly Procedures : Replacement Procedures
5. Carefully remove the power wire assembly [37] by using a pair of long nose pliers to push the
power wire assembly connector inward as shown in Figure 6-54 .
Figure 6-54. Removing Power Wire Assembly from the Chassis
6. Separate the mating connector [D] of wire assembly [27] from the PA-unit board kit [20] as
shown in Figure 6-55 .
Figure 6-55. Removing Mating Connection from PA-Unit Board Kit
7. Using a CR-V PH2 screwdriver, remove the 2 binding head screws, M3x6 SUS [6] from the
antenna connector [32] as shown in Figure 6-56 .
Figure 6-56. Removing Screws from Antenna Connector
Power Wire Assembly
Mating Connector [D]
1
2